EnviroSeal

EnviroSeal

CONCENTRATED CONCRETE SEALANT TO PREVENT EFFLORESCENCE


EnviroSeal is a concentrated, low-cost sealer for both older and new concrete surfaces. When applied to concrete or masonry, it reacts with the calcium in concrete to increase moisture resistance, concrete hardness and chemical resistance. When used prior to MasonryGuard, the two-part system prevents efflorescence and increases the service life of the coating.

Size Availability: 5 Gallon Pail
Shelf Life: 12-24 Months

Safety Data Sheet
Tech Datasheet
Product Label

EnviroSeal is a concentrated, low-cost sealer for both older and new concrete surfaces. When applied to concrete or masonry, it reacts with the calcium in concrete to increase moisture resistance, concrete hardness and chemical resistance. When used prior to MasonryGuard, the two-part system prevents efflorescence and increases the service life of the coating.

USES

All cementitious surfaces especially in unconditioned and moisture prone areas such as, basements and crawl spaces

SURFACES

EnviroSeal is used to protect and seal above and below-grade masonry construction materials including but not limited to poured concrete, pre-formed concrete, brick, concrete block and mortar joints. Other surfaces include poured subfloors, piers, structural poured and block formed walls.

FEATURES/BENEFITS

  • Corrosion, Abrasion and Chemical Resistant.
  • Permanently reacts with concrete to resist efflorescence
  • Hardens concrete, minimizes dusting, spalling and hairline cracking

SAFETY

Consult SDS for details

APPLICATION

EnviroSeal is formulated to be diluted.
It dilutes at a rate of 3-parts water to 1-part EnviroSeal concentrate. The solution may be applied with a brush, squeegee, sprayer (power or manual) or scrubbing machine for several minutes to obtain an even penetration. Three to four light, penetrating coats are recommended. After each coat is applied, allow EnviroSeal to penetrate. Complete drying is unnecessary. Any excess EnviroSeal should be removed between coats with clean water. New concrete should be properly cured for a minimum of seven days before EnviroSeal is applied.

COVERAGE RATE

Each light coat will yield 300-400 ft2 of coverage. Once all coats (3-4) are applied, expect a final coverage rate of 100 ft2 per ready-to-use gallon. Coverage may vary due to surface texture, porosity, age and application method. This does not include loss from over-spray or over-use.

EcoSafe

  • Non-toxic with high LD50 values
  • No VOC’s (no volatile organic compounds)
  • Non-flammable, No APE’s, Sodium and Chlorine-free
  • Biodegradable (safe for people, pets and plants)

Proven

Works for:

  • Poured and Pre-formed Concrete
  • Concrete Block and Mortar Joints
  • Brick with Mortar Joints
  • Stone with Mortar Joints

Powerful

  • Increases chemical resistance
  • Prevents efflorescence
  • Hardens concrete
  • Minimizes dusting, spalling and hairline cracking
  • Prepares surface for MasonryGuard

Priced Right

  • EnviroSeal is a concentrate that dilutes to a water-thin solution, making it fast and easy to apply for professional contractors.

Additional information

Packaging Variations

5 Gal Pail

Shelf Life

12-24 Months